Thingiverse
090 Shellder Dual Low-Poly
por bradicai
15
Descargas
13
Likes
0
Makes
Pokemon 090 Shellder Dual extrusion Low Polygon
Prints in one piece without supports. Included a single extruder version.
You can make it a 4color print if you are capable of adding a pause command at certain layers in your slicer or manually(which i don't recommend).
I also included a model for his "belt", which isnt really part of the original styling but the shell was looking a little plain since most the color is inside the model.
The IRL picture is 10cm tall 3 shells(0.4W 0.2H) and 20%infill. And I haven't printed the single color version or the version without the belt but they should print the same just without extra walls between the parts.
Pause right before the pearl starts and then again right before the tongue starts
Prints in one piece without supports. Included a single extruder version.
You can make it a 4color print if you are capable of adding a pause command at certain layers in your slicer or manually(which i don't recommend).
I also included a model for his "belt", which isnt really part of the original styling but the shell was looking a little plain since most the color is inside the model.
The IRL picture is 10cm tall 3 shells(0.4W 0.2H) and 20%infill. And I haven't printed the single color version or the version without the belt but they should print the same just without extra walls between the parts.
Pause right before the pearl starts and then again right before the tongue starts
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
