MakerWorld
RC
Ver Modelo
1:10 RC Wheel Display No Hardware, Stackable
26
Descargas
22
Likes
10
Makes
Here is my RC wheel display, the pins press into the front and rear faces. It is printed in seperate pieces to save on time and material instead of printing supports between the front and rear faces. It holds 4 wheels inside and you could place 2 more on top, if you pirint multiple you can place then next to each other or flip one of the stands upside down and place it on top of the other. It is made for on road 1:10 52mm wheels, there is enough room to store wheels with rally block tyres too. The pins are a very tight fit, depending on your printers tolerances, you may need to adjust the ends of the pins with a little bit of sanding/filing Boost MeIf you like this print please consider boosting it, its very much appreciated.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!