1:10 scale RC trailer

This is a 1:10 scale RC trailer made in SW. Requires eight 15x21x4mm bearings to be inset into the frame. Four 5x10x4mm and four 10x15x4mm bearings for standard RC car front axle stubs. Should fit any short style car springs. (around 20mm height by 13mm I.D.). Use M3 screws to lock the frame together. Use any rod end you want that fits on an M3 screw. Run Car spec wheels with 6mm (or up) thick hexes depending on wheel offset.
Part #'s: Stubs MST 310049
-I may continuously be changing tolerances on the trailer parts.
-The trailer is on the third edit.
Instructions:
print qt.
1 of everything except:
2 fenders
2 ramps
2 passenger arms
2 driver arms
4 (pick which wheel spacing torsion arm you want, the number is hex thickness for a +11 offset standard RC car wheel)
-may have to shave some components to fit