Thingiverse
1/1400 Scale Constellation Class
door Vasator
118
Downloads
77
Likes
0
Makes
Currently working on re-meshing this model in blender to remove any non-manifolds:
August 8, 2019 - Fixed the bottom saucer (uploaded Saucer_Bottom_0_Manifolds_2019.stl) this one I had to fix the bottom of the model, Blender was not showing any non-manifolds but there were some where the model touches the plate.
August 11th, 2019 - Working on fixing the (Nacelles_Top_Bottom_Fixed.stl) file by separating each piece into it's own file and fixing the many non-manifolds. Uploaded (Torpedo_Tubes_print_two_0_manifolds_2019.stl) which is the small torpedo tubes that rest between the engine nacelles. Print two of these
December 18th, 2017 - Uploaded Saucer_Middle_0_Manifolds_2.stl - Fixed all non-manifolds in Blender, also re-meshed the model to save filament with the center section open. Opened in Cura and Slic3r Prusa Edition and looking good
December 17th, 2017 - Uploaded Saucer_Top_0_Manifolds.stl - removed all non-manifolds in blender, tested in Cura and Slic3r Prusa Edition,
August 8, 2019 - Fixed the bottom saucer (uploaded Saucer_Bottom_0_Manifolds_2019.stl) this one I had to fix the bottom of the model, Blender was not showing any non-manifolds but there were some where the model touches the plate.
August 11th, 2019 - Working on fixing the (Nacelles_Top_Bottom_Fixed.stl) file by separating each piece into it's own file and fixing the many non-manifolds. Uploaded (Torpedo_Tubes_print_two_0_manifolds_2019.stl) which is the small torpedo tubes that rest between the engine nacelles. Print two of these
December 18th, 2017 - Uploaded Saucer_Middle_0_Manifolds_2.stl - Fixed all non-manifolds in Blender, also re-meshed the model to save filament with the center section open. Opened in Cura and Slic3r Prusa Edition and looking good
December 17th, 2017 - Uploaded Saucer_Top_0_Manifolds.stl - removed all non-manifolds in blender, tested in Cura and Slic3r Prusa Edition,
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!