1/2 Inch Wood Plug

Check out my other goodies at Makersteve.com

I was missing a few 1/2 inch wood plugs for the old Futon so I ginned these up. They will work fine for anything 1/2 inch. Great for wood working.

Since my Shelf pegs (https://www.thingiverse.com/thing:2669456, https://www.thingiverse.com/thing:2669397) were a hit, I figure these would be well received also.

I suggest .2mm for the print and a little paint.

If you are new to 3D printing or have a CR-10 and want to pep it up, check my about page in my profile.. lots of good info there.

I work for tips and you all don't tip (except for one of you) so, please consider using these affiliate links for the Filament, or, click on and then buy some dog food (that happened). Give it a try https://amzn.to/2NCT39Z

I will print it on my Creality CR-10S https://amzn.to/2xNxecL only $529.00 on Amazon!

For some quality, inexpensive PLA that is MakerSteve Approved, check out DazzleLight PLA from $11.99 a roll with coupon. https