Thingiverse
1/2" PVC Pixel Clip
door jlange
83
Downloads
35
Likes
0
Makes
This is a slight modification of the 1/2" PVC clip found at https://www.thingiverse.com/thing:4088932.
This clip features a channel at the bottom to allow RGB pixel wires to run though the clip while still allowing the pipe to sit flush. The base stand-off was also extended to provide 1/2" of height.
This clip features a channel at the bottom to allow RGB pixel wires to run though the clip while still allowing the pipe to sit flush. The base stand-off was also extended to provide 1/2" of height.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!