1.3 Oled flexible screen holder

I was looking for a holder for a 1.3 inches OLED screen that I connected to an arduino, but I couldn't find anything where I could change the angle of the screen, to aim the view at both adults and children. Also, a lot of them are chunky and print in a long time. I must admit, though, that I took some inspiration for my design from one these existing designs (will add a link when I find it) My project is split in two pieces, I managed to print them in 12 minutes both and shold be resistent enough, at least if don't do anything dangerous with it. Need 6 M3 screws for assembly, I suggest you get the flat or round heads, the ones I had in stock have this massive hex head that makes the holder much bigger than what it is Rotation:Screen can reach up to an upstanding position, basically 90 degrees with the base, while the only limit when bending backwards is only the pins from the screen and the cables Printed in PLA 3DQF Glitter Blue, just because this is what I had loaded in the