Thingiverse
1.3" OLED surface mount bezel
von Jimmers2222
15
Downloads
15
Likes
0
Makes
This is a surface mount bezel to hold a 1.3" OLED screen on an RC airplane with minimal size hole needed.
It prints face down with no support needed. The screen can be held in with a bit of glue in each screw hole.
It prints face down with no support needed. The screen can be held in with a bit of glue in each screw hole.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!