Thingiverse
1/4-20 Cable Clip
by LouiSharman
56
Downloads
48
Likes
1
Makes
1/4"-20 Cable clip.
This is designed mainly for cinema cameras, to screw into a cheeseplate/other 1/4-20 hole to better organise cables on your build.
Prints in 2 pieces, the clip and the screw.
Print with Supports (Everywhere), it's only the clip that needs them, screw can print without.
I found that a 3 line skirt did the job, no need for brim or raft.
I lowered my speed down to 40m/s for better accuracy on the threads but it can probably be printed faster.
If you can't get the screw through the clip at first, try thread a metal 1/4-20 screw through first, then the plastic one should fit after.
This is designed mainly for cinema cameras, to screw into a cheeseplate/other 1/4-20 hole to better organise cables on your build.
Prints in 2 pieces, the clip and the screw.
Print with Supports (Everywhere), it's only the clip that needs them, screw can print without.
I found that a 3 line skirt did the job, no need for brim or raft.
I lowered my speed down to 40m/s for better accuracy on the threads but it can probably be printed faster.
If you can't get the screw through the clip at first, try thread a metal 1/4-20 screw through first, then the plastic one should fit after.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
