1/48 Scale Stinger

This is a fully articulated, glue in place, Stinger from Battletech scaled to 1/48 scale.

Use 1.75mm filament as alignment pegs and everything should line up without too much trouble, but be aware that if you rescale it, then you will need to redo the holes or find another material to go into the alignment holes. You will also need to adjust the thickness of the Elbow and Knee parts to get them to fit in their joints, as the clearance for them is tight. The toe and heel parts will likely also need their thickness adjusted if you rescale the model, as a heads up.

No supports needed. Will print on FDM printer with 0.4 nozzle (recommended layer height is 0.08) but I do recommend a simple brim to help hold on to the printer bed. Do recommend cleaning up the brim on any area you think you can't get to after it is glued together, then glueing it and then removing the remaining brim material. This will help fill in the seam between the two parts nicely. As always file/sand away at any