Thingiverse
1.75" UTV Rollcage windshield mount
von Embalm
84
Downloads
42
Likes
0
Makes
I have not tested this on my Rhino other than for fitment. It seems pretty durable as long as its not over tightened onto the rollcage. Plan is to use (2) 3/8" bolts for the windshield and (2) 1/4" bolts for the rollcage clamp. I plan on using 8 clamps total 2 on each side and drilling holes in the lexan to match the mount. This was printed as one piece and works well. it takes a little tug to free up the hinge but after that no problems.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!