1/87 APC V2

Was supposed to be 1/87, but then I actually modeled a 1/87 person approximately 6ft (21mm) tall.... The APC doors looked pretty small comparatively. So the APC is actually somewhere between 1/87 and 1/100. This model was created in Designspark Mechanical and printed on a Zortrax M200 at 140 micron in Black and Red Z-ABS.

Features include:

-Removable top
-Swiveling turrent
-Swing-down rear door
-Swing suspension
-Free rolling
-Display base to show suspension working

Need 1mm rod for axles and hinges.
For axles, the rods need to be 30mm long.
For door hinges, the rods are 15mm.
For the main rod on which the axles swing, a 94mm rod is required.
For the turrent hinge, a 10mm rod is needed.

NOTE: May need to drill out holes. Non-swing (squared) axle should be put as the third axle.