Thingiverse
1 inch beadlock wheels
von marinmio
22
Downloads
17
Likes
0
Makes
•1 inch beadlock wheels
•these are a replica of the aluminium one you can found on aliexpress, put 3.5mm less
wider so they fit on the fms fcx24m
•the one on the first picture are the aliexpress one that i've machined, but the 3d printed one have the same spec (offset, diameter, width...)
• print in 3 pieces and use 6 m1.4x6mm to lock them in place
•the little round things at the bottom of the pieces are grips pads to avoid warping, cut them off once printed
•these are a replica of the aluminium one you can found on aliexpress, put 3.5mm less
wider so they fit on the fms fcx24m
•the one on the first picture are the aliexpress one that i've machined, but the 3d printed one have the same spec (offset, diameter, width...)
• print in 3 pieces and use 6 m1.4x6mm to lock them in place
•the little round things at the bottom of the pieces are grips pads to avoid warping, cut them off once printed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
