10 Cable CAT8 CAT6 Mountable Comb

Wanted to organise my cable runs in my rack from the patch panel to devices/exits. Unfortunately I made the error of getting some CAT8 cables which just did not play nicely with other combs I have tried as they are slightly thicker. If I scaled them up my other cables would fall out.

So after playing in TinkerCAD I managed to come up with my own design which allows enough flexibility to slide in all my cables but they don't easily slip out of their grooves. Additionally I added an indentation to fit in my velco ties, or standard cable ties. This put enough pressure on it to hold it in place, but also stop any cables slipping out.

Finally added as second tier to allow me to mount these horizontally or vertically to secure the cable run

I may end up shrinking the holes to allow a slightly firmer fit after I complete my full runs.