Slicer Discord
10 Inch Network Rack Basics – 3D printable model from MakerWorld MakerWorld
Electronics

10 Inch Network Rack Basics

537 Downloads
156 Likes
210 Makes
Go to Model
A few months ago I have seen a YouTube talking about a 10 inch (25.4 cm) 10U network rack specifically for Raspberry Pi's, I loved this idea until I have seen that it was nearly $200 for me to pick up the bare-bones rack. This lead to the research and development of this project. The basic legs design was by McBig server rack on pintables. His design was very good, but to get working for what I wanted I needed to make a few little changes to meet my standards. Completely re-designing the handles and legs, and legs as well as designing side struts to provide strength when you go past 1 level of 5U's. I will be uploading different rack items I have designed to allow different modules to be added into the rack. What is here is just the basic structure to get you started, you will need M5-6 nuts and bolts, at least 2 inches (ca. 51 mm) long. For this I just picked up a 500 piece nuts and bolts set off Amazon for $10. All in with Filament, to but the rack that can be seen in the pho
Category
Electronics
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection