10 inch Server/Network Rack using M3 Screws

Wanted a 10 inch rack to hold all of my networking hardware and clean up some of the mess. I looked at all the ones here on MakerWorld but decided that it would be a lot more fun to design my own. I didn't want to use M6 screws and cage nuts so decide to use M3 screws and threaded inserts. Also decided to make my own thumbscrews using 16mm screws and hex nuts. I used 52 M3 inserts, 46 M3 x 16mm and 8 M3 x 8mm screws. All of the black is printed using BamBu Lab PETG HF and the sides and knobs were printed in Bambu Lab Bone White PLA. The top and bottom are the same along with the sides. Both however will just fit on a 256mm bed. I have an H2D so that's what I used for the large pieces. I also printed all of the panels face down on the build plate because I like the look from the textured build plate. With the 100 and 150 mm trays sticking up in the air they get VFA's at the top but it's inside so who cares….. The assembly is very straight forward, if you start at the bot