Slicer Discord
10" Rack - Half rack panels for network devices  – Modelo 3D imprimible de MakerWorld MakerWorld
Gadgets

10" Rack - Half rack panels for network devices

48 Descargas
12 Likes
7 Makes
Ver Modelo
I recently renewed my network setup at home with Unifi devices. That included Unifi Gateway Ultra, Switch Lite 8 POE. At first I stacked them on each other but it would have bad effect like thermal issues and also not good in terms of aesthetic and maintenance.I spent a little time to design some panels which are parameterized and I can adjust them to any other network devices easily only by supplying width,length and depth. I try to update this project with all small devices from Unifi to make it perfect, if there are any other devices you like just send me the depth, length and width and I make the model for you.Updates:08/04/2024 : Added Ubiquiti EdgeMAX EdgeRouter PoE 5-Port Router (ERPoe-5)08/04/2024: Added Mikrotik RB5009UG+S+IN08/04/2024: Added Ubiquiti EdgeSwitch 10XPPrint settings Print orientation: I always print them on the bottom to have strength vertically, it'll be a little difficult to fit them into small printers (25x22cm bed) like Prusa MK3S+. For those printers yo
Categoría
Gadgets
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección