100 Sized True X Micro Quadcopter

100 sized micro quad.
This was designed because of the protection it gives to the hardware components.
Inspired by other sandwich type quadcopters.

Designed with M3 nylon screws in mind.

The top layer needs to be tapped with a M3 screw or tap.
If you don't want to tap the top layer you will need to drill out the hole so a nylon screw will fit through the whole assembly. M3x25 nylon screw will be needed to pass through whole assembly.

Frame weight is around 16 grams with recommended settings below.

FPV camera mount has yet to be designed. Currently I have just hot glued the camera in place.

Hardware supported.
Motors: 1104, 1105, 1106 brushless.
Props: Up to 2 inch props.
Flight Controller: 16 and 20 mm sized.
ESC: 4in1, 16 and 20 mm sized
FPV: Currently I only know that a Eachine lizard 95 FPV camera will fit.