Thingiverse
100mm (4inch) quick clamp trigger
by Isolt
52
Downloads
76
Likes
0
Makes
100mm or 4" quick clamp trigger replacement.
No support is required.
You may need to drill out the hole to 5.2mm 13/64" so that it rotates freely on the pin, otherwise it will stick and not return.
Printed 5 walls in PETG-CF
No support is required.
You may need to drill out the hole to 5.2mm 13/64" so that it rotates freely on the pin, otherwise it will stick and not return.
Printed 5 walls in PETG-CF
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!