Tools
Go to Model
100mm dust separator (4inch)
580
Downloads
330
Likes
0
Makes
I made this due to not being able to find a 100mm cyclone (4inch).
I have it hooked up to my 1200CFM extractor and it works great, when the bin is full it wont clog up, excess chips just to into your extractor bin.
Printing:
I printed mine on my prusa i3 mk3 and it will max out the print space.
0.3mm layer height and I did mine at 100% infill but that could be over kill
You will need to glue to two top pieces together and the two bottom pieces together
I have it hooked up to my 1200CFM extractor and it works great, when the bin is full it wont clog up, excess chips just to into your extractor bin.
Printing:
I printed mine on my prusa i3 mk3 and it will max out the print space.
0.3mm layer height and I did mine at 100% infill but that could be over kill
You will need to glue to two top pieces together and the two bottom pieces together
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!