Thingiverse
DaVinci 1.0 Spool Hanger
3
Downloads
10
Likes
0
Makes
This is a remix of http://www.thingiverse.com/thing:409100.
This assumes you have a modified XYZprinter that can accept spools other than the original cartridge.
The original spool hanger by Ranh316 was too small for the spools I use, so I started over using his basic premise.
The spools that I use have an inside diameter of 59mm. These are 2LB spools that I order from eBay.
The hanger was beefed up to support the additional weight.
Bearings and end caps for the spool were create
This assumes you have a modified XYZprinter that can accept spools other than the original cartridge.
The original spool hanger by Ranh316 was too small for the spools I use, so I started over using his basic premise.
The spools that I use have an inside diameter of 59mm. These are 2LB spools that I order from eBay.
The hanger was beefed up to support the additional weight.
Bearings and end caps for the spool were create
Sign in to leave a comment
Sign in