Espresso Tamping Stand with Tamper rest

This tamping stand has a place to put your tamper when you're not using it.

The tamper rest is 60mm, so it should nicely fit a 57mm or 58mm tamper without being too tight.

The scad file always references the most recent version of this file.

Tamping_Stand_rest2.stl has been printed and works well without any supports or rafts. Build time was 4h30m on a Replicator 1 clone (Flashforge) printer at .27mm resolution.

Tamping_Stand_rest3.stl has not yet been printed. I found that the smal