Thingiverse
104245 Battery Sled
von GhostTrex16
0
Downloads
0
Likes
0
Makes
Designed and made a battery sled for the 104245 size Battery for my MeshCore Repeater.
Uses 2 m3 screws (Length depends on where you're mounting it)
Printed in PETG for Heat tolerance (my project sits in sunlight)
Recommend 3-4 wall loops for screw ear, holes are 3mm
There are 2 half-moon-shaped cuts; those were initially for zipties, but I ended up not using them.
Uses 2 m3 screws (Length depends on where you're mounting it)
Printed in PETG for Heat tolerance (my project sits in sunlight)
Recommend 3-4 wall loops for screw ear, holes are 3mm
There are 2 half-moon-shaped cuts; those were initially for zipties, but I ended up not using them.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
