Thingiverse
Mobile crank handle
door bmorin
9
Downloads
3
Likes
0
Makes
It's summer time in Norway, and I decided to repair the handle of the crank to close the shutters on my balcony.
This replacement handle is made of several parts:
- the handle, which you should print twice
- the "clip", which you should print once
The clip goes around the shaft. It should be able to rotate but not to move vertically. I had to put the clip in hot water (~100 degC) for one minute to be able to install it.
I recommend putting neoprene glue on the edges to assemble the
This replacement handle is made of several parts:
- the handle, which you should print twice
- the "clip", which you should print once
The clip goes around the shaft. It should be able to rotate but not to move vertically. I had to put the clip in hot water (~100 degC) for one minute to be able to install it.
I recommend putting neoprene glue on the edges to assemble the
Makes
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
Inloggen