Thingiverse
Printable Piggy Bank
by belch
377
Downloads
343
Likes
7
Makes
Printed on Rep 2
Infill 0%
Shells = 3 or 4 depending on the thickness you want. Old school. Break to open...
No raft
No support
Added a second STL, with a flat spot and bridging design around the coin slot, as I had some trouble printing the coin slot. I think this would be very slicer dependent, I see the new makerware seems to want to use diagonal fills instead of horizontal - and that leaves a little clean up on the finished part around the coin slot. Would be interested in ot
Infill 0%
Shells = 3 or 4 depending on the thickness you want. Old school. Break to open...
No raft
No support
Added a second STL, with a flat spot and bridging design around the coin slot, as I had some trouble printing the coin slot. I think this would be very slicer dependent, I see the new makerware seems to want to use diagonal fills instead of horizontal - and that leaves a little clean up on the finished part around the coin slot. Would be interested in ot
Sign in to leave a comment
Sign in