Thingiverse
Belt Guide Printrbot Simple 1405
by averypierce
16
Downloads
10
Likes
0
Makes
v3: hole spacing fixed
v2: corners trimmed so it wont bang into http://www.thingiverse.com/thing:377357 if you're using it
This will 100% keep your belt from slipping off the bearings, which was a frequent problem after I widened my print area due to the extra belt travel and crooked bearings.
The holes should be 7mm in diameter to fit over the screws, definitely measure it and make sure everything is sized right since you have to take the printer half apart to install it.
The scre
v2: corners trimmed so it wont bang into http://www.thingiverse.com/thing:377357 if you're using it
This will 100% keep your belt from slipping off the bearings, which was a frequent problem after I widened my print area due to the extra belt travel and crooked bearings.
The holes should be 7mm in diameter to fit over the screws, definitely measure it and make sure everything is sized right since you have to take the printer half apart to install it.
The scre
Sign in to leave a comment
Sign in