MyMiniFactory
3D Print of Himeji Castle - Japan
by Unknown
0
Downloads
0
Likes
0
Makes
Resin print, with a height of 130mm for about 1:300 scale. The figure next to it is N scale (1:160).
It was very difficult to hollow the mesh, which is necessary for Resin printing both to greatly reduce material and warping. Chitubox and Meshmixer failed because there is lots of spurious geometry inside.
I finally managed in Prusa slicer with lots of patience, and manually adding a few internal supports.
It was very difficult to hollow the mesh, which is necessary for Resin printing both to greatly reduce material and warping. Chitubox and Meshmixer failed because there is lots of spurious geometry inside.
I finally managed in Prusa slicer with lots of patience, and manually adding a few internal supports.
Sign in to leave a comment
Sign in