Thingiverse
simple Bouncer Metz 58 AF
by Horex1200
46
Downloads
40
Likes
1
Makes
Hello,
this is a very simple bouncer for Metz Mecablitz AF 58.
It fits without any hard to print mechanism to the flash-head. The light is published very soft in all directions. I made it to shoot photos indoor at lower light. So the light is reflected by walls and top of the room and the shadows are much softer.
To print i used ABS (natural) without support at 100 % Infill at 0.2mm layer height.
On the Top, the sphere has a few small holes, but i think that does`nt matter.
The Spher
this is a very simple bouncer for Metz Mecablitz AF 58.
It fits without any hard to print mechanism to the flash-head. The light is published very soft in all directions. I made it to shoot photos indoor at lower light. So the light is reflected by walls and top of the room and the shadows are much softer.
To print i used ABS (natural) without support at 100 % Infill at 0.2mm layer height.
On the Top, the sphere has a few small holes, but i think that does`nt matter.
The Spher
Sign in to leave a comment
Sign in