Thingiverse
NCS P3-v Steel Raspberry Rumba mount for NCS P3-v Steel
by trentjw
8
Downloads
7
Likes
0
Makes
1. Mount uses standard mount holes on P3 Steel printers
2. Mount both Rumba board and Raspberry Pi on same bracket
3. use standard Raspberry Pi case to mount to bracket
4. use 2 3mm screws for mount pins up to 12mm in length
5. added optional spacers 9mm tall for smaller printers where clearance is an issue
6. added the ability to use the Vilros Case
1 https://www.vilros.com/shop/raspberry-pi/raspberry-pi-3-clear-case/
2 also comes as a kit at amazon https://www.amazon.com/Vilros-Rasp
2. Mount both Rumba board and Raspberry Pi on same bracket
3. use standard Raspberry Pi case to mount to bracket
4. use 2 3mm screws for mount pins up to 12mm in length
5. added optional spacers 9mm tall for smaller printers where clearance is an issue
6. added the ability to use the Vilros Case
1 https://www.vilros.com/shop/raspberry-pi/raspberry-pi-3-clear-case/
2 also comes as a kit at amazon https://www.amazon.com/Vilros-Rasp
Sign in to leave a comment
Sign in