Thingiverse
Vortex LemonRX Holder + LED Protector
by luisbc92
7
Downloads
3
Likes
0
Makes
Final 3D Printed LED protector and holder for Lemon RX receivers.
It is designed to be press fitted to the frame. The main receivers also fits snuggly, if not stick a piece of velcro on the inner part to hold it in place. It does not fall off, even on hard crashes ;)
There are two versions, one with only the main receiver, and one with a satellite holder.
Print with the flat side down, 0.2mm layer height, 50% infill. You can go higher on the infill to get a stronger part but from my exp
It is designed to be press fitted to the frame. The main receivers also fits snuggly, if not stick a piece of velcro on the inner part to hold it in place. It does not fall off, even on hard crashes ;)
There are two versions, one with only the main receiver, and one with a satellite holder.
Print with the flat side down, 0.2mm layer height, 50% infill. You can go higher on the infill to get a stronger part but from my exp
Sign in to leave a comment
Sign in