Angle Mount for Acer K132 LED Projector

This is a projector angle clamp that I made for my Structured Light Scanning Rig. I use the David 3D scanning software. This clamps to a 1.5" x 1.5" right angle 1/8" aluminum rail or it can mount on a tripod. There is a little over 15 degree range of movement with the locking
straps or 90 degrees without. The 5.1 mm holes are tapped with a 1/4 - 20 thread. I recommend at least 3 perimeter shells to allow for the tap to thread properly. I printed the top in 3 different settings using Simplify 3