3D Print of 100 card (Commander) customisable deck box with magnetic latch.

Not sure if the model was updated after Yulka's comment - but I had no issues. Works nicely, just a little bit fiddly when inserting the inner box and aligning the gears. Magnet fits are a bit tight, and due to printing at .32mm height, I had to sand down the magnet slot at the front before I was able to fit a 10mm magnet in.
Latch also does not close very tightly. Even with 2x N50 10x2mm magnets, it could still "open on its own" - if it werent for the weight of the cards holding the inner box d