Thingiverse
The Simple Car
8
Downloads
5
Likes
0
Makes
A simple car designed in SketchUp and 3D-printed on a MakerBot Replicator 5th Edition. This print was also a test of the acetone vapor finishing: a small amount of acetone was heated over a hot plate in a sealed glass pot, with the model inside supported by four screws screwed into a wooden base to minimize contact surface area. After the model had been surrounded by the acetone vapors for several minutes, the pieces were removed and assembled using "Instant Arrow Glue" (comparable to Gorilla Gl
Sign in to leave a comment
Sign in