Improved Velleman K8200 Y Axis Part

Basicaly if you tighten the screws on the bearings holder of Y-Carriage on K8200 (and maybe also 3D-Rag), this will change the angle of the linear bearings a bit, increasing the tension of movement. So I made this little part in FreeCAD to improve it. Now the Y-Movement is much smoother and noise reduced. The X/Y size matches perfectly, so I still can adjust the bed level. I just made it ca. 1 mm taller, so it hits the upper end of the end switch (I also plan to put a protective cover for this s