Thingiverse
NexStar 6SE Dewshield
by apexio
8
Downloads
3
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/9kaM0xHEqeC
ABS. 0.2mm layers, 30% infill. This is a tall and thin print. If the corners lift, try supergluing them down after the first 20 layers or so.
After printing, paint acetone over the entire outside. It makes a nice glossy finish and really increases the strength.
The dewshield has a flange that friction fits onto the 6SE. You can glue the extension onto this print to get a full 240mm dews
ABS. 0.2mm layers, 30% infill. This is a tall and thin print. If the corners lift, try supergluing them down after the first 20 layers or so.
After printing, paint acetone over the entire outside. It makes a nice glossy finish and really increases the strength.
The dewshield has a flange that friction fits onto the 6SE. You can glue the extension onto this print to get a full 240mm dews
Sign in to leave a comment
Sign in