Thingiverse
10lb spool holder
von Domo1981
1
Downloads
1
Likes
0
Makes
Based off another design I found on here. I would link it but I can't find it again. works really well, no need to change size. use a regualr skateboard bearing (22mmOD 8mmID)
Print at 50% because you do have to hammer the bearing into the "spindle"
Print at 50% because you do have to hammer the bearing into the "spindle"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!