Slicer Discord
10mm LED clips – 3D-Druckmodell von Thingiverse Thingiverse

10mm LED clips

von kaoshavoc
1 Downloads
0 Likes
0 Makes
Zum Modell
This is for using double sided tape, I use the kind I can get at the dollar tree, comes off in small squares almost exactly this size. You would think it's welded on after its been there a couple hours, no lie, will remove paint when you take them off if your not careful. Very sleek, you don't even notice them, the waterproof 10mm lights fit in tight and you can put them every so often.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Bemalen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen