Ramps 1.4 to Solidoodle SD3 Motherboard Electronics Adapter

This adapter allows you to mount a Ramps board to the existing hole pattern found on the back of the SD3. A snap on/off 40mm fan helps to cool the electronics.

Instructions: Print the two parts. Line the base up to the back of the printer. Screw in the left side screws (M3x10mm) on top and bottom first. Do not screw in the right side yet. Line up the ramps board over the holes. Use 2 longer screws (at least M3x30mm) to thread through the holes in the Ramps and Arduino boards and all the