BeagleBone Black - Simple Case

Simple Lasercut case for Beaglebone Black by TI.
------
No fancy backwards compatibility to the old beaglebone or anything. this is just a quick way to get your board wrapped up in something. You'll need **4 M3 screws + Nuts (40mm length works best) or some glue, or both**. Add your own layers to make room for capes.

If you have 3mm material only, just cut the file attached(i exported in a few formats..) and you're good to go.

If you have 4mm material as well, you may replace layers 2&