Back
3DSEARCH / VPAS 8 Leg Ends 20mm
VPAS 8 Leg Ends 20mm – 3D printable model from Thingiverse Thingiverse

VPAS 8 Leg Ends 20mm

by caffeinatedsoap
7 Downloads
3 Likes
0 Makes
Download Model
multicopter vpas 8
For the VPAS 8, 3 of these will be needed.

Recommended:
Print out of nylon.
Test fit. If loose, glue on.

For more information and build instructions see:
http://www.velocitypigeon.com
Source
Thingiverse
Comments
0

Comments

No comments yet – be the first!
All Thingiverse Models More by caffeinatedsoap

Similar Models

6 Suggestions
VPAS 8 Equipment Level 3mm holes
VPAS 8 Equipment Level 3mm holes
by caffeinatedsoap
↓ 13 ♥ 10
VPAS 8 Leg Bracket 5mm Holes
VPAS 8 Leg Bracket 5mm Holes
by caffeinatedsoap
↓ 7 ♥ 5
multicopter battery tray , corner led mount
multicopter battery tray , corner led mount
by husyildiz
Multicopter motor mount for 1/2" square booms
Multicopter motor mount for 1/2" square booms
by The-3D-Printing-Guy
↓ 14 ♥ 10
multicopter GPS stalk
multicopter GPS stalk
by The-3D-Printing-Guy
↓ 2
Multicopter Receiver Holder
Multicopter Receiver Holder
by SleepyPanda
↓ 1

Add to Collection