Thingiverse
Blame Stick
by Styx2015
7
Downloads
11
Likes
0
Makes
Sliced in Simplify 3D
Set layer height to 0.25
In process settings - advanced - set "stop printing at height" to 1.0
Print first colour
Change colour
In process settings - advanced - set "start printing at height" to 1.25
Glue the 2 halves together
Blame someone !
Credit for this design goes to Tony Norton
http://www.thingiverse.com/azuto77/about
Set layer height to 0.25
In process settings - advanced - set "stop printing at height" to 1.0
Print first colour
Change colour
In process settings - advanced - set "start printing at height" to 1.25
Glue the 2 halves together
Blame someone !
Credit for this design goes to Tony Norton
http://www.thingiverse.com/azuto77/about
Sign in to leave a comment
Sign in