Bulldog XL++ (a Bulldog XL despaghettification accessory)

Filament was sometimes spaghettified from my Bulldog XL. Closer analysis of the design showed that there is quite a large gap from the hobbed surface to the exit hole; this 3d printed accessory fills the gap and eliminates any deviance of the filament. As a side effect; it also makes it easier to feed in the filament.

Instructions:
- Print with high infill (95% perhaps).
- Clean up print with sandpaper; it's quite a tight fit so any protrusions/blobs will make it impossible to fit.
- Drill