Thingiverse
Stops warping of ABS & Nylon prints, Enjoy it!
by Chris918
88
Downloads
109
Likes
0
Makes
After a bit of experimenting, I have found what I believe to be the very best, most consistent method to stop warping of ABS & Nylon ( possibly other plastics.)
I use Blue Painters Tape on heatbed, then brush on a thin layer of Elmers Washable Clear School Glue. In my opinion it provides the perfect adhesion properties. ABS and Nylon both stick great to it (even if your bed is not perfectly level!). Equally impressive is the fact that when you remove the print, it will pop off without excess
I use Blue Painters Tape on heatbed, then brush on a thin layer of Elmers Washable Clear School Glue. In my opinion it provides the perfect adhesion properties. ABS and Nylon both stick great to it (even if your bed is not perfectly level!). Equally impressive is the fact that when you remove the print, it will pop off without excess
Sign in to leave a comment
Sign in