Auto level Cyclops effector

WIP

So i needed a Z probe for the e3d cyclops for use with my micromake kossel.
I used an inductive probe but got off readings due to the probe being so far away from the hot end (y -30mm) and effector tilt.

So i came up with this.

It uses the micromake v3 effector. i modded it for more clearance.
This will let you use a e3d cyclops nozzle as the Z-probe.


Set up the same as the micromake effector.
For those that dont know. That means the Z probe offset in firmware will be a posi