Robo3d Latches for Mikes enclosure

These are a set of hinges for the enclosure designed by Mike Kelly. Here: http://www.thingiverse.com/thing:681843. These hinges can be installed without drilling any holes in the Robo3d cover. You would thread and install 2 set screws in the 2 holes shown. You slide the hinges onto the case and tighten the set screws. The part of the hinge that goes onto the plexiglass has 2 holes but I found that there was only enough room for 1 flat head screw. If you want to use 2 screws, you would have to