Thingiverse
ATX power supply Velcro mounting (underdesk)
0
Downloads
3
Likes
0
Makes
Hey Community!
This is an underdesk mounting kit for your atx power supply. I have configured the side height that it aligns with the power supply. The Velcro I used is from 3M (electrical tape) with 25 mm width.
For Printing I turned off the support structure since I was afraid that the small bridges on the back (for holding the Velcro) are supported as well.This results in a little cleaning work, since the first layer hangs in the air. But inserting the tape worked out just fine.
If someo
This is an underdesk mounting kit for your atx power supply. I have configured the side height that it aligns with the power supply. The Velcro I used is from 3M (electrical tape) with 25 mm width.
For Printing I turned off the support structure since I was afraid that the small bridges on the back (for holding the Velcro) are supported as well.This results in a little cleaning work, since the first layer hangs in the air. But inserting the tape worked out just fine.
If someo
Sign in to leave a comment
Sign in