Thingiverse
Pergo Bed Stiffeners
by Pergo
24
Downloads
11
Likes
0
Makes
This may work on printers other than a Robo3D/R1/R1 Plus
The 8mm rod(s) are 24 mm shorter than your glass length.
** Warning remember your working with glass! be sensible in the amount of correction you try to make. If you apply TOO much shim you could break the glass. I some cases the glass is between $30-$50.00
When I created my 330mm Y Rails upgrade for the Robo 3D
http://www.thingiverse.com/thing:1154745
I learned that my bed glass was .02 mm lower at a certain point that at other p
The 8mm rod(s) are 24 mm shorter than your glass length.
** Warning remember your working with glass! be sensible in the amount of correction you try to make. If you apply TOO much shim you could break the glass. I some cases the glass is between $30-$50.00
When I created my 330mm Y Rails upgrade for the Robo 3D
http://www.thingiverse.com/thing:1154745
I learned that my bed glass was .02 mm lower at a certain point that at other p
Sign in to leave a comment
Sign in