Back
Hate Ticks? – 3D printable model from Thingiverse Thingiverse

Hate Ticks?

by jpearce
60 Downloads
73 Likes
1 Makes
Download Model
This is an experimental device to remove ticks. Put tick through the big hole - flat side against your skin. Pull along skin while pressing down to force the tick down the channel. Make sure you get the 'blades' under the head. Fortunately, we are at the end of tick season here...

I make no warranties that this will actually do anything useful or keep ticks from vomiting disease into your bloodstream. If you do happen to get a tick, print it out, give it a try before you reach for the tweez
Source
Thingiverse
Comments
0

Comments

No comments yet – be the first!
All Thingiverse Models More by jpearce

Similar Models

6 Suggestions

Add to Collection