Slicer Discord
120mm Dustfilter – Modelo 3D imprimible de Thingiverse Thingiverse

120mm Dustfilter

por Dionarap
31 Descargas
36 Likes
0 Makes
Ver Modelo
Deutsch:
Ein Luftfilter zum entstauben der Raumluft.

Es wird benötigt:
2x 120mm PC-Lüfter
Filtermatte/Filterflies (ca.175x120x5mm)
div. elekt. Stecker (für Stromverbindungen)
12V Netzteil mit ausreichender Leistung

Die PC-Lüfter sollten perfekt in das Filtergehäuse passen und nicht herausfallen. Es ist auf die Richtung des Luftstroms zu achten, ein Lüfter drückt die Luft in den Filter, der andere saugt sie hinaus.
Die FIltermatte wird einfach zwischen die beiden Teile eingeklemmt.

Beide PC-Lüfter habe sind paralell mit dem Netzteil verbunden.

English:
An air filter for dedusting the room air.

required:
2x 120mm PC fan
Filter mat / filter fleece (approx.175x120x5mm)
div. Elect. Plug (for power connections)
12V power supply with sufficient power

The PC fans should fit perfectly in the filter housing and not fall out. Pay attention to the direction of the air flow, one fan pushes the air into the filter, the other sucks it out.
The filter mat is simply clamp
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Polycarbonate
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Dionarap también publica en

31 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección