Thingiverse
120mm fan rack
door uzosan
3
Downloads
3
Likes
0
Makes
A standard 120mm PC fan can be installed in this fan rack. Fitting fan mounting holes are also available.
I designed the rack to circulate the accumulated heat behind my fireplace. But I'm sure there are other use cases too.
Support should not be needed to print. My Ender was able to bridge the gap.
The joints between the parts are very tight. Depending on the precision of your printer, you may need to sand them a little.
I designed the rack to circulate the accumulated heat behind my fireplace. But I'm sure there are other use cases too.
Support should not be needed to print. My Ender was able to bridge the gap.
The joints between the parts are very tight. Depending on the precision of your printer, you may need to sand them a little.
uzosan publiceert ook op
21 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!